Intended Use; Smartphonegrip Product Features - Bosch BSP3200 Instrucciones De Servicio Originales

English – 6
The Bosch SmartphoneGrip is designed to hold and
charge a smartphone on the handlebars of a Bosch
eBike system.
In addition to the functions outlined here, changes to
software relating to troubleshooting and functional
modifications may be introduced at any time.
The SmartphoneGrip is suitable for cycling on rein-
forced paths without jumps and with few ledges
(7)
(6)
(5)
All illustrations of bike parts except for the drive unit,
SmartphoneGrip including operating unit, speed sen-
sor and the corresponding holders are schematic and
may differ on your eBike.
0 275 U08 3SG | (28.02.2022)

SmartphoneGrip Product Features

(1)
(10)
(9)
(1)
(8)

Intended Use

(< 15 cm) at average speeds of between 9.32 and
15.53 mph, for example on asphalt roads, country
paths, paths reinforced with gravel or sand, and rein-
forced woodland paths.
If used incorrectly, there is a danger that the smart-
phone may detach from the holder, fall down and
therefore become damaged. There is also a consider-
able risk of an accident if the smartphone falls out.
(4) (2)
(1) Front retraining bracket, movable
(2) Rear retaining bracket, fixed
(3) USB port with USB cap
(4) Release mechanism
(3)
(1)
Bosch eBike Systems