Cleaning & Use Guidance - Costway EP24744DE Manual Del Usuario

ON/OFF：Power Supply CLEAN: CLEAN button
ICE FULL: water full alarm ADD WATER: water shortage alarm
ICE MAKING: ice making
1.Plug in the power supply, the "ICE MAKING" indicator flashes, and the
machine will start the deicing function.
Press the ON/OFF button, the "ICE MAKING" indicator light is always
on and then the ice block will be made automatically. After the ice
making is completed, the deicing will be carried out, and then the ice
shoveling function will be entered, and so on.
2.ADD WATER: water shortage alarm: when the light is red, it means
water shortage in the water tank. You need to add water and press the
POWER button to restart the machine.
3.ICE FULL: ice full alarm. When the ice reaches the maximum amount
of ice storage container, the "ICE FULL" light flashes and the machine
stops. At this time, the ice needs to be poured out. When the ice position
is lower than the full sensor position, the machine will restart
automatically.
4.ICE MAKING: Ice making
When this light is always on, it means that the ice maker is making ice.
5.CLEAN: Plug in the power supply, the "ICE MAKING" indicator
flashes. Pressing the CLEAN button, start the cleaning function.
Cleaning duration is 150 seconds. Do not disconnect the power supply
during cleaning. After cleaning, the product will automatically enter the
standby mode.
OPERATION INSTRUCTIONS
Step 1
Open the lid and take out the basket and add water to the reservoir.
Note: There is a maximum scale MAX in the reservoir. The water should
not exceed the MAX position. If the water exceeds the maximum scale
MAX, you need to open the bottom drain plug, release the excess water,
and cover with a transparent cover.
Step 2
Plug in the power and press the ON/OFF button to start the machine.
06
CAUTION
1. When the indoor temperature is lower than 15 degrees, please
choose small ice. When the indoor temperature is higher than 30
degrees, it is recommended to choose big ice.
2. The three cycles used for the first time, the ice produced is small and
irregular.
3. When the ice basket is full, please take out the ice immediately, do
not let the ice overflow the ice basket.
CLEANING & USE GUIDANCE
1.Clean the inner liner, ice collecting tray, water box, ice shovel and
evaporator frequently. When cleaning, unplug the unit and remove the
ice cubes. Use a diluted solution of water and vinegar to clean the inside
and the outside surface of the Ice maker. Do not spray Ice maker with
chemicals or diluted agents such as acids, gasoline or oil. Rinse
thoroughly before starting.
2.Keep ventilation openings in the appliance enclosure, or in the built-in
structure, clear of obstruction. Do not use mechanical devices or other
means to accelerate the defrosting process, other than those
recommended by the manufacturer.
3.Reuse the machine after being idled for a period of time, it may not
have enough water to pump for air retard, in this case, the water
shortage indicator "ADD WATER" will be on. Repress POWER button to
restart the ice maker .
4. To ensure the cleanness of ice, please change water for water
reservoir at least once one day. If do not use for a long time, please
drain the water out and clean it up.
5.If the compressor takes a strike action for shortage water, fully water
or interruption of power supply, it will delay for 3mins to start up after
restart.
6.Always use fresh water before starting ice production either at initial
installation or after a long shut-off period.
07