Introduction; Safety Rules; Regional Requirements - Aethra X5 Guia Rápido

Safety Rules

Regional Requirements

All manuals and user guides at all-guides.com

INTRODUCTION

INTRODUCTION
DEVICE IN CLASS I
Always connect to a grounded socket.
To guarantee continuous protection for operator safety, only use the mains adapter supplied with the
device.
WARNING: for power supply connection use an easily accessible outlet located near the device.
Never remove the mains plug for permanent connection.
Connect the ISDN port to a network termination only (NT1). It is absolutely forbidden to connect the system to
an outdoor telecommunication line.
Connect the LAN port to an internal LAN circuit only. It is absolutely forbidden to connect the system to an
outdoor telecommunication line.To guarantee continuous protection for operator safety, make sure that the
Network interface is always inserted.
If the Network Interface is not in place, do not under any circumstances remove the cover.
The change from cold to hot environments can cause the formation of condensate inside the device. To
avoid malfunctioning, wait at least 2hours before connecting the device to the supply mains.
In case of fire, absolutely avoid using water to extinguish it.
WARNING: RISK OF ELECTRIC SHOCK
The power supply used by this device involves lethal voltage levels.
Do not access internal parts of the device (and/or of the power supply unit).
If objects or liquids penetrate inside the device, immediately disconnect the power supply cable. Before
using the device again, have it checked by specialized staff.
Refer to qualified staff for service.
In case of intervention, always check that the power supply has been completely and successfully
disconnected.
Laitte on liitettävä suojamaadoituskoskettimilla varustettuun pistorasiaan
Apparatet må tilkoples jordet stikkontakt.
Apparaten skall anslutas till jordat uttag.
13