Uline H-8743 Manual Del Usuario página 2

Figure 2
Figure 3
Figure 4
PAGE 2 OF 9
ASSEMBLY CONTINUED
2. With miter cut J trim installed, center one of four slatwall
panels into J trim channel with male end facing up.
Ensure neither end of slatwall extends beyond ends of
miter cut J trim. (See Figure 2)
3. Drive screws through slatwall grooves into studs using
pencil marks as guide. Ensure screws are at least
2" from ends of panels and only screw in part way.
Screws will be tightened at end of assembly.
(See Figure 3)
4. Set second slatwall panel on top of first and align
ends. Ensure bottom groove is seated firmly and
completely onto tongue of first panel. Repeat step
three to secure second slatwall panel to wall.
(See Figure 4)
NOTE: Take note where studs are located and
mark wall with a pencil just above slatwall panel.
0621 IH-8743