LEGRAND 0 590 56 Manual De Instrucciones página 20

3. Using the terminal with RFID keycards
Enable the RFID reader
In the RFID tab, switch to using mode
a) Connect your cable to the terminal
Swipe the keycard in front of the terminal
The white indicator lights ash on the cable side = > charging starts
b) Swipe your keycard in front of the terminal:
the green indicator lights ash
Connect your cable (maximum duration:
1 minute; after one minute, swipe the keycard in front of the terminal again)
Charging starts
Unregistered keycard:
If an unregistered keycard is swiped in front of the terminal:
red indicator lights ash
19