Troubleshooting Guide - Philips Supervapor GC6048 Manual De Instrucciones

ENGLISH
14

Troubleshooting guide

If you are unable to solve your problem by means of the troubleshooting guide below, please contact
the nearest Philips service centre, the Philips Customer Care Centre in your country or contact us
online at www.philips.com.
Problem
When I switched the appliance on for
the first time, I saw some smoke
coming out of the appliance.
Droplets of water escape from the
soleplate.
The appliance does not produce
steam.
I see no steam coming out of the
soleplate.
The soleplate is dirty.
All manuals and user guides at all-guides.com
Possible cause(s)
This is normal. Some parts of the iron
have been greased lightly in the
factory.
The temperature dial (I) has been set
to a temperature that is too low for
steam ironing.
The steam tank has been placed on an
unstable and/or uneven surface.
When you start steam ironing, the
hose is cold. Steam condenses in the
hose, causing droplets of water to
escape from the soleplate.
The steam tank has not been switched
on.
The 'steam tank heating up' pilot light
is still on (types GC6024/6026 only).
Superheated (i.e. high-quality) steam is
hardly visible, especially when the
temperature dial has been set to
maximum position and even less so
when the ambient temperature is
relatively high.
Impurities or chemicals present in the
water have deposited on the soleplate.
You have been ironing at too high
temperatures.
Solution
This phenomenon will cease after a
short while.
Select the required ironing
temperature as indicated in these
instructions and the table.
Put the steam tank on a stable and
even surface.
This is normal. Hold the iron over an
old cloth and press the steam activator
button (M).The cloth will absorb the
drops. After a few seconds the steam
production will have normalised.
Push the on/off switch (E) to set it to
'on' position.
Wait until the pilot light has gone out.
To check if the iron is actually
producing steam, hold a (cold) mirror
in front of the soleplate vents.
Clean the soleplate with a damp cloth.
Clean the soleplate with a damp cloth.
Select the recommended ironing
temperature.