Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Technical data
Angle Grinder
Order number
Power input
Frequency
127V
Amperage
220V
RPM unload
Capacity discs cutting / grinding ø:
Spindle threed
Weight
Machine components
1 Lock up button
2 Support
3 Switch
4 Button
5 Air vents
6 Auxiliary handle
7 Collar
8 Spindle
9 Guard
10 Pin Spanner
11 Protective guard with cutting guide*
12 Mounting flange
13 Clamping nut
14 Grinding discs*
15 Cutting discs*
* Not all of the accessories ilustrated or described are in-
cludedas standard delivery.
General instructions
These tools have been desingned to perform the largest
amount of jobs of its class, thus provind high performance,
speed and perfection.
Noise/vibration information
Measured values determined according to EN 50 144.
Typically the A-weighted noise levels of the tool are:
Sound pressure level: 90 dB (A). Sound power level:
103 dB (A).
Wear ear protection!
The typical weighted acceleration is 5,5 m/s
Information regarding statics
Slots in structural walls are subject to DIN 1053 part 1 or to
provisions specific to a particular country.
These provisions must always be complied with. Before
starting work, consult the structural engineer or architect re-
sponsible, or the relevant supervision of works.
GWS 14-180
0 601 280 0 ..
1400 W
50/60 Hz
11,6 A
6,7 A
7000 min
–1
180 mm (7")
M 14 x 2
3,3 kg
Important for you safety
In addition, the general safety instructions on page 14
must be followed. Before using for the first time, ask for
a practical demonstration.
• For all work with the machine, the auxiliary handle 6 must
be mounted.
• When working with a roughing or cutting disc, the guard
9 must be mounted.
• Observe the instructions of the manufacturer for the
mounting and use of grinding tools.
• Use only grinding tools whose allowable speed is at least
as high as the no-load speed of the machine.
• Check grinding tools before use. The grinding tool must
be properly mouted and turn freely. Perform a test run for
at least 30 seconds without load. Do not use damaged,
out round or vibrating grinding tools.
• Pay attention to the dimensions of the grinding disc. The
.
mounting hole diameter must fit the mounting flange 12
2
without play. Do not use reducer pieces or adapters.
• Protect the grinding tool from inpact, shock and grease.
• The machine must be used only for dry cutting/grinding.
• Use dust extraction when working with stone and wear a
dust mask. The vacuum cleaner for the extraction must
be qualified for masonry dust. When cutting stone, use
the cutting guide.
•
Working safely with this machine is possi-
ble only when the operating and safety infor-
mation are read completely and the instruc-
tions contained therein are strictly followed.
•
If the cable is damaged or cut through while
working, do not touch the cable but immediate-
ly pull the mains plug. Never use the machine
with a damaged cable.
•
Wear protective goggles, ear protetors and face
mask. When necessary, also wear an apron.
•
Wear protective gloves and sturdy shoes.
•
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
11
Publicidad
Tabla de contenido
