Mute Function - Trevi SB 8316 TV Manual Para El Uso Y La Conexión

ENGLISH
VOLUME ADJUSTMENT AND MUTE FUNCTION
It's possible to adjust the volume of the unit with the volume buttons (10, 11 on the device, 15, 17 on the remote control)
- Press the + or buttons to increase the volume of the device.
- Press the - or button to decrease the volume.
MUTE FUNCTION: For activate Mute function press MUTE button (14) on the remote control; the indication on the display will
begin to flash. To resume the playback, press the MUTE button (14) again.
Caution:
• Some audio outputs which you connect the Sound Bar (like headphone output) can have its own volume control:
make sure you have set on the source device an adequate level audio output otherwise the Sound Bar will sound
even at maximum volume.
• If the sound played by the Sound Bar be distorted means that the input signal is too strong: lower the volume of
the Sound Bar or paid on a level audio source device output more low.
• In case of connection to a TV by headphone output, it may happen that the sound reproduced by the Soundbar
is low even at maximum volume; in this case try connecting the Soundbar to the audio-scart output using an
adapter (not supplied).
PRE EQUALIZATIONS
The sound bar has a pre-set equalization system, press one of the buttons (18, 20, 22, 23) on the remote control according to
the type of listening you are making:
- Press the audio equalization button
- Press the 3D button (20) audio equalization for listening with surround effect.
- Press the audio equalization button
- Press the audio equalization button
HDMI IN (ARC)
The HDMI ARC function is designed to reduce the number of connecting cables between a TV and a soundbar. The audio signal is
able to travel in both directions to and from the speakers, thereby improving sound quality and signal latency.
To connect the TV to the sound bar with HDMI ARC, check that the cable is HDMI 1.4 or higher. The HDMI ARC functionality is
only available using the appropriate output (HDMI ARC) on the TV or other device.
You may need to change the external speaker settings on your TV to enable HDMI ARC commands.
1. Connect the HDMI (ARC) output of your TV or any other HDMI ARC compatible device to the soundbar's HDMI ARC port (4)
using an HDMI 1.4 cable (not supplied);
2. Go to the Menu of your TV and make sure the HDMI ARC output is activated. Refer to the instruction manual of your TV to
know how and where to activate this output;
3. Press M button (12) on the unit or the MODE button (26) on the remote control repeatedly until the word "ARC" appears on the
display;
4. The TV audio will be automatically muted from its speakers and switched to the sound bar; the volume can be adjusted using
TV's remote control or sound bar remote control.
(18) for listening to the Music.
(22) for Voice listening.
(23) for MOVIE.
10
SB 8316 TV