Fcc Statement - Anker A1641 Manual De Instrucciones

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures: (1)
Reorient or relocate the receiving antenna. (2) Increase the separation between
the equipment and receiver. (3) Connect the equipment into an outlet on a
circuit different from that to which the receiver is connected. (4) Consult the
dealer or an experienced radio / TV technician for help.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. The device can be used in portable exposure
condition without restriction.
Product Name: Anker 633 Magnetic Battery (MagGo)
Model: A1641
The following importer is the responsible party (for FCC matters only).
03
Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: +1 800 988 7973
IC Statement
This device complies with RSS‐216 of Industry Canada. Operation is subject to
the condition that this device does not cause harmful interference.
Déclaration d'Industrie Canada
Cet appareil est conforme à la norme RSS-216 d'Industrie Canada. Son
utilisation est sujette aux conditions voulant que cet appareil ne cause aucune
interférence nuisible.
RSS-Gen Issue 5 March 2019
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada's licence-exempt
RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
RSS-Gen numéro 5 mars 2019
Cet appareil contient des émetteurs / récepteurs exemptés de licence
conformes aux RSS (RSS) d'Innovation, Sciences et Développement
économique Canada. Le fonctionnement est soumis aux deux conditions
suivantes:
(1) Cet appareil ne doit pas causer d'interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris celles
susceptibles de provoquer un fonctionnementindésirable de l'appareil.
Tout changement ou modification non expressément approuvé par la partie
responsable de la conformité pourrait annulerl'autorité de l'utilisateur à utiliser
l'équipement.
RF exposure statement
The equipment complies with IC Radiation exposure limit set forth for
uncontrolled environment. The device can be used in portable exposure
04