Eu Declaration Of Conformity - Anker A1641 Manual De Instrucciones

condition without restriction.
This device complies with Industry Canada license-ICES-003. Operation
is subject to the following two conditions: (1) This device may not cause
interference, and (2) This device must accept any interference, including
interference that may cause undesired operation of the device.
This digital apparatus complies with CAN ICES-003(B)/NMB-003(B).
Le présent appareil est conforme aux CNR d' Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
This product complies with the radio interference requirements of
the European Community.

EU Declaration of Conformity

Hereby, Anker Innovations Limited declares that the product type A1641 is in
compliance with Directives 2014/53/EU & 2011/65/EU. The full text of the EU
declaration of conformity is available at the following internet address:
https://www.anker.com/
This symbol indicates that this product shall not be treated as
household waste. Instead it shall be handed over to the applicable
collection point for the recycling of electrical and electronic equipment.
GB Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A1641 is in
compliance with Radio Equipment Regulations 2017 and The Restriction of the
Use of Certain Hazardous Substances in Electrical and Electronic Equipment
Regulations 2012. The full text of the GB declaration of conformity is available
at the following internet address:
https://www.anker.com
05
This device was tested for typical body-worn operations. The device has
been evaluated to meet general RF exposure requirements. The device can
be used in portable exposure condition without restriction. Third-party
belt-clips, holsters, and similar accessories used by this device should
not contain any metallic components. Body-worn accessories that do not
meet these requirements may not comply with RF exposure requirements
and should be avoided. Use only the supplied or an approved antenna.
This device is in compliance with the essential requirements and other
relevant provisions of UKCA. All essential radio test suites have been
carried out.
Anker Innovations Limited
Room 1324-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong
Kong
The following importer is the responsible party (contract for EU and UK
matters)
Anker Innovations Deutschland GmbH
Georg-Muche-Strasse 3, 80807 Munich, Germany
Anker Technology (UK) Ltd
Suite B, Fairgate House, 205 Kings Road, Tyseley, Birmingham, B11 2AA, United
Kingdom
06