RoMedic FlexibleSling Instrucciones De Uso página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35
FlexibleSling with undivided leg supports,
Application of the sling when the patient is lying in bed, on a stretcher or on the floor
FlexibleSling with divided and undivided leg supports,
Removal of the sling when the patient is recumbent
Alternative application
Lifetime information & Periodic inspection
The product has an expected lifetime depending on how the product is used according to the manual instructions.
The service life of the product varies depending on usage frequency, washing, drying, etc. Please be sure to read the
product label and follow the care instructions for this product on www.directhealthcaregroup.com.
I F U
1
2. To ensure that the sling is correctly applied and that its mid-section is
aligned with the patient's spine, you can fold the back section up against
the patient's back.
3. Turn the patient back onto the sling and pull out the head support, back
section and leg support. Connect the strap loops to the slingbar, starting
with the upper strap loops, and then the leg supports. Start raising the
slingbar, and then stop to ensure that everything is as it should be before
3
lifting the patient from the underlying surface.
1. Turn the patient towards you. Place the
sling so that the product label is facing the
underlying surface and the sling's mid-section
follows the spine. The upper edge of the
sling should be high enough so that the sling
supports the head and the lower edge is level
with the tailbone. Place the sling as far in
under the patient as possible. Push the back-
2
section loop under, so that you can reach it
once you have turned the patient back onto
the sling.
Turn the patient towards you and fold the sling in
under the patient so that the fabric slides towards
you when you pull it out after you have turned back
the patient.
The sling's high back provides good head support
while allowing the patient to hold his/her arms inside
or outside the sling.
For the model with divided leg supports, usually, the
leg supports are crossed before they are hooked to
the slingbar.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido