BWT BC Serie Manual Del Usuario página 13

 Wear complete eye protection, gloves, and protective clothing when the
battery pack is being removed.
 Avoid touching the wires altogether and avoid contact between them and
any metal items, which could cause sparking and/or short circuit the battery.
 Never smoke or allow a spark or flame in the vicinity of the battery or the
pool vacuum.
 Do not expose the battery to fire or intense heat as this may result in an
explosion.
CAUTION!
If a battery leak occurs, avoid any contact with the leaking fluids and place the damaged
battery in a plastic bag.
-
If leaking fluids come in contact with skin and clothing, wash immediately with plenty
of soap and water.
-
If leaking fluids come in contact with eyes, do not rub them and immediately flush them
with cool running water for at least 15 minutes. Seek medical attention as soon as
possible.
How to remove the battery pack(To be carried out by authorized technician)
Recommended tools (not included): Screwdriver.
WARNING! The pool vacuum must be disconnected from the supply mains
before removing the battery pack.
1. Place the pool vacuum on a flat surface. Use the screwdriver to pry open
the small cover and unfasten the 4 screws. Remove the battery from the
chamber.
2. Remove the battery from the unit and locate the battery cable connector.
Press on the clip of the connector to pull it out. NOTE: Wrap the connector
immediately with insulating tape in order to avoid any short circuit caused
by the contact of both wire terminals.
12/155