Set-Up Before Use - BWT BC Serie Manual Del Usuario

3. Connect the external adaptor to the power source. The indicator light on
the external adaptor will turn red when the vacuum is charging and green
when it is fully charged. Charge it for 5-6 hours for best performance.
• Immediately disconnect the external adaptor from the power source if you
detect any of the following:
- Offensive or unusual odor
- Excessive heat
- Deformation, cracks, leaks
- Smoke
4. When charging is complete, disconnect the external adaptor from the
power source and unplug the charging cable from the main unit.
WARNING! Never leave the charging cable while the pool vacuum is in
the water.
Normally the pool vacuum is designed to operate for up to 75 minutes on a full charge.
Note: Empty the filter bag regularly. Excessive debris increases the burden to the motor
and may shorten the operating time.
NOTE: Rechargeable lithium-ion battery is classified as a consumable item. It has a
limited life and will gradually lose its capacity to hold a charge. Therefore, the running time
of the pool vacuum will gradually reduce after repeated charging and discharging
throughout its product life.
Once the lifespan of the battery reaches its end, refer to section "BATTERY DISPOSAL"
for instructions regarding battery disposal.
NOTE: Let the pool vacuum rest for around 30 to 40 minutes before charging it again.

Set-Up Before Use

Telescopic pole (not provided) assembly
Press on the V-clip on the pole connector to retract its side pins. Slide the telescopic pole
into the connector until it's locked in place by the side pins and holes and then release the
V-clip.
RED light - Charging
GREEN light - Charged
(for EU & US only)
5/155