Missing Or Damaged Parts - Difrax S Instrucciones De Uso

The S-bottle warmer is taking a very long time to switch of
If heating takes longer than expected, this may be due to the
starting temperature of the food. Food that has only just been
taken out of the fridge will be colder, so the S-bottle warmer will
take longer to reach the correct temperature
Alternatively, the heating element with the temperature meter
may be calcified. This means that heat cannot escape or that the
meter does not register the correct temperature. It is important
to clean the element thoroughly after each use and descale
regularly (once every 3 months) for optimal operation. If the
problem persists after cleaning, contact the Difrax customer
service
The food is getting too hot
Before serving, always check the temperature of the food. Test
a few drops on the inside of your wrist. you should not feel any
tingling in this spot. If you do, the food is too hot
If the food is too hot, the temperature meter on the heating
element may be calcified. This means that heat cannot
C
escape or that the meter is not registering the correct
temperature. It is important to clean the element thoroughly
after each use and descale regularly for optimal operation.
If the problem persists after cleaning, contact the Difrax
customer service
18
The food is lukewarm/cold
The S-bottle warmer is set to a temperature of 37 °C *. This
temperature was chosen with your baby's safety in mind.
For you this may feel lukewarm/cold because your own body
temperature is higher. 37 °C * Is the ideal drinking temperature
for your baby. The bottle may feel colder on the outside, but the
food in the bottle is at the right temperature
A vacuum is created in the S-bottle
This may be because the O-ring valve
Press open the raised section of the valve between two fingers
before inserting the O-ring and make sure that the raised section
is sticking upwards
The blockage may also be due to dirt or calcification. In that
case, we advise you to clean and dry the O-ring valve after use
to avoid e.g. calcification

Missing or damaged parts

loose parts of the Difrax S-bottle warmer such as the O-ring
valve are sold separately via www.difraxshop.com or via the
Difrax customer service
Tip: visit www.difrax.com regularly for the latest innovations
* +/- 2 °C
is closed or blocked.
B
19