Control Panel - Pur Line VENTY TO 40 Manual De Instrucciones

OPERATION
ASSEMBLY BEFORE USE:
Mount the main body of the appliance and the front/rear base:
1. Remove the two parts of the base from the box, so that the holes of the two-part base are aligned and the
two parts are formed into a complete base.
2. Run the power cord through the base, align the base with the holes on the fan body, then secure the power
cord under the base clip to tighten the base with the fan body.
3. When the base is disassembled, screw out the screws first, and then take the base out.
After the four posts are aligned and wrapped, firmly snap
the base front inward (a sound can be heard), then use the
same method to snap the base back.
To disassemble : Hold the clip and forcibly pull the base out, after the clip comes out, use the same method to
remove another clip.

CONTROL PANEL:

- ON/OFF: Press once this button to turn on the device. Press again this button to turn OFF.
- SPEED: Press this button to select desired fan speed, LOW-MID-HIGH, in circle turns. The corresponding air
flow speed indicator light will be displayed.
- MODE: Press this button to select desired wind mode, NORMAL-NATURE-SLEEP. The mode "Sleep" or "Nature"
indicator light will be displayed.
NORMAL: the normal wind mode is the Low, Medium & High fan speed speeds.
NATURE: automatically selects wind speed randomly. The natural wind also has low, medium and high speeds.
SLEEP: Sets a mode to low, medium or high, the ventilation speed changes as follows:
1. High: the air flows with high speed for half an hour, then drops to medium speed for half an hour, and finally
drops to low speed.
2. Medium: the air flow begins with medium speed for half an hour and finally drops to low speed.
3. Low: the air flows at a low natural wind speed, till the preset time is reached or the fan is turned off.
- SWING: Press once this button to make swing of louvers, the SWING indicator will be displayed. Press again
to cancel this function.
- TIMER: It can be set between 1 to 12 hours, increase by 1 hour intervals. The numeric display shows the time.
EN
After the base is put on the fan body,
follow the schematic to secure the power
cord under the base clip, then tighten the
screws.
8