Appliance Recess For Campers, Caravans And Motor-Homes; Fixing The Appliance; Electrical Connection; Important - Vitrifrigo DW Serie Manual De Instrucciones

Appliance recess for campers, caravans and motor-homes.

To install the refrigerator or fridge units in a caravan, camper van, motor home etc.
make the recess space in the vehicle with ventilation vents directly on the outside, fitted
with suitable grilles to ensure that all possible live parts of the appliance are not directly
accessible (thermostat, control unit and fan). The grilles must have openings with max.
dimensions 5 mm and be on at least one side (see annex 2 Fig. 1-2).
ATTENTION
Keep ventilation openings free from obstructions in the recess. Do not place any
objects or other materials near the ventilation grilles, nor cover or block them.

Fixing the appliance.

To secure the appliance in the recess space, use the holes on the fixing profile or, if
present, the fastening elements inside the housing.

6. ELECTRICAL CONNECTION

ATTENTION (only for models with alternating current): The operator must be able to
disconnect the appliance from the mains electricity.
Therefore, make sure that there is an access point to the electrical power supply near the
appliance and/or that the system is equipped with a 6A omnipolar circuit breaker with a
contact opening of at least 3mm and a minimum differential sensitivity of 0.03A.
Before connecting the product, make sure that the voltage corresponds to that shown
on the identification label or that shown on the label on the compressor.
IMPORTANT: by law, the appliance must be earthed.
Make sure that the earthing system for the electrical network is working perfectly.
We accept no responsibility whatsoever for any injury to people or damage to property
deriving from the failure to properly comply with this regulation.
The use of adaptors, multiple sockets and extension cords is not recommended.
In the event that the appliance's plug and the socket are not compatible, replace the
plug with a suitable one.
This operation must be done by a suitably qualified person who must ensure that the
cable section of the plug is appropriate to the power absorbed by the appliance.
Do not interconnect any other type of appliance to the refrigerator.
Electrical connection for models 12/24Vdc and 12/24Vdc/100-240 Vac 50/60Hz
It is recommended to connect the 12Vdc or 24Vdc power supply line directly to the
30 ENG