Correct Positioning Of The Burner Caps; Fire Fighting Device (Ffd) - Edesa EGG-6030 TI TR CI N Manual De Instrucciones

Correct positioning of the burner caps

Grills and burner caps must be positioned correctly for the hob to operate properly. (Figure 1)
Ignition pipe and parts of the burner that is related to the ignition function must especially be
very well positioned on the determined place.
Please ensure that the flame is blue and there is no noise. If the flame is yellow or there is
noise during the first ignition, turn off the hob and check that the burners are fully seated.
Please consult the authorised service provider if there is no change in the situation.
CORRECT INCORRECT
Figure 1

Fire fighting device (FFD)

All burners on your hob are equipped with a flame failure device against the risk of going out
for any reason (flood, wind etc.). If the flame goes out when the burner knob is turned on, this
system shuts off the gas supplied to the burner, preventing the ambient from filling with gas.
When the burner is shut off for safety reasons, turn the hob's burner knob to the off position
and wait for at least 60 seconds to repeat the ignition procedure. Repeat the ignition
procedure after 60 seconds.
IGNITER
THERMOCOUPLE
3