Technical Data - Edesa EGG-6030 TI TR CI N Manual De Instrucciones

 For conversion, remove the burner caps and flame rings on the hob. Remove the
injectors according to the figure above and replace them with injectors of suitable
diameters specified in the user manual.
 Remove the knobs and rubber seals of the hob, and carry out the procedure using the
flat precision screwdriver in a manner that it faces the valve adjustment screw.
 To set the low flame position, rotate the gas adjustment screw on the valve and set the
minimum gas flow. Fit the burner assembly of the adjusted burner, ignite the burner
and set the knob to minimum position before making this adjustment.
 The flow regulating screw must be loosened when LPG hobs are being converted into
natural gas, and tightened when natural gas hobs are being converted into LPG.
 After converting the hob, fit the rubber seals first and then the knobs to complete the
procedure.
These instructions must be applied by the authorised service provider. The product must be
installed correctly and in accordance with the applicable directives.
The hob must be disconnected from the power supply before carrying out any procedure. The
type label on the hob shows the gas type for which the hob has been designed.
After fitting the injectors, use soap to check for gas leakage. To do this, apply suds
to the bottom side of the injectors.
Put your finger on the injector to block the gas outlet and check if there are
bubbles on the connection point of the injector.

Technical data

Technical Information About Gas Burners
(G20-20 mbar) - (G30/G31; 28-30 /37mbar)
Burner A Burner SR
1 kW 1.75 kW
G30-30 G30-30
Mbar LPG Mbar LPG
(0.50 mm) (0.65 mm)
G20-20 G20-20
Mbar NG Mbar NG
(0.72 mm) (0.97 mm)
Burner R Wok Burner
3 kW (2.5 kW)
G30-30 G30-30
Mbar LPG Mbar LPG
(0.85 mm) (0.82 mm)
G20-20 G20-20
Mbar NG Mbar NG
(1.15 mm) (1.15 mm)
16
Wok Burner Wok Burner
(3.8 kW) (4 kW)
G30-30 G30-30
Mbar LPG Mbar LPG
(0.98 mm) (1.01 mm)
G20-20 G20-20
Mbar NG Mbar NG
(1.35 mm) (1.50 mm)