Publicidad
STEP 1
Measure at least 34-3/4"
(882.7mm) from the top
of your closet panel. By
using the guide block and
dowels, this will provide
a platform to ensure both
arms are even on both
sides (See Fig. 1).
STEP 2
If you are installing into a
12" or 14" depth closet
you will install the pull-
down arm assembly to the
front edge of the closet
panel as shown. (See Fig.
2A)
For all other closet depths
(16" and 20") you will
install at least 14" from
the rear of the closet. (See
Fig. 2B)
STEP 3
Using the provided flat
head wood screws, install
all of them except the last
three front screws (See
Fig. 3).
2
34
3
/
"
4
(882.7mm)
MINIMUM
FIGURE 2A
12", 14" DEPTH
FRONT
GUIDE BLOCK
FIGURE 3
X
X
X
Customer Service: 800-626-1126 | rev-a-shelf.com
FIGURE 1
GUIDE BLOCK
16", 20" DEPTH
FRONT
GUIDE BLOCK
FIGURE 2B
14" MINIMUM
Publicidad
