Installation; Commissioning; System Requirements; Copying Original Files - EHEIM LEDcontrol 4200120 Manual De Instrucciones

English

5. Installation

The appliance is operated in conjunction with EHEIM powerLED+ lights. Heed the operating manual for the lights, especially the chapters on safety,
commissioning, operation and maintenance!
Danger! Electrocution!
▶ Do not place the appliance on or within the aquarium cover!

6. Commissioning

6.1 System requirements

PC with operating system (WIndows XP to Windows 10)

6.2 Copying original files

In addition to the software, the USB card included in the scope of delivery contains several of the lighting modes made available to you by EHEIM. In order to
guarantee future access, proceed as follows:
1. Insert the USB card in the USB port of your PC.
2. Copy the entire content of the USB card to a corresponding directory on your PC.
The original EHEIM lighting modes can also be downloaded at: www.eheim.com

6.3 Setup

1. Connect the LED controller to your computer via the USB data cable.
The EHEIM powerLED+ light and power supply unit do not have to
be connected to the controller.
2. Install the EHEIM V2.0 program by double-clicking on EHEIM Setup.exe.
You will then be guided through the installation.
3. Start the program following successful installation.
4. Click on [Language]or the button combination[alt-l] and select the
desired language.
5. Click on to synchronise the clock of the controller with the clock of
your computer, see chapter 7.2 Time synchronisation of the control-
ler with your computer, page 27.
If the synchronisation is successful, an acoustic signal will be
emitted by the controller and you will receive a confirmation
message.
6. Close the message with [OK].
7. Disconnect the controller from your computer.
8. Connect the controller to the light and power supply unit (⌦B).
9. The controller now controls your EHEIM powerLED+ light in the preset
mode fresh01 day.
26