Viewing The Lighting Mode In A Quick Run-Through; Transferring The Lighting Mode To The Controller - EHEIM LEDcontrol 4200120 Manual De Instrucciones

English

7.7 Viewing the lighting mode in a quick run-through

7.8 Transferring the lighting mode to the controller

‧ In order for the controller to be able to control the EHEIM LEDpower+ light with the desired lighting mode, the lighting mode must be transferred to
the controller.
‧ There can always only be one lighting mode on the controller. Therefore, only one lighting mode may be transferred to the controller.
‧ The EHEIM powerLED+ light and power supply unit do not have to be connected to the controller.
1. Connect the controller to your computer via the USB data cable.
2. Connect the EHEIM powerLED+ light and the power supply unit to the
controller.
3. Insert the power supply unit in the mains socket.
4. Start the program EHEIM V2.0.
5. Load your lighting project, see chapter 7.4 Loading a lighting project,
page 28.
6. Read the desired lighting modes, see chapter 7.5 Reading and viewing
the lighting mode, page 28.
7. Save the lighting project.
8. Mark the lighting mode that you wish to view in a quick run-through.
9. Click on in order to start the quick run-through. An acoustic signal
will be emitted by the controller.
10. Click on in order to stop the quick run-through. An acoustic signal will
be emitted by the controller.
1. Connect the controller to your computer via the USB data cable.
2. Start the program EHEIM V2.0.
3. Load your lighting project, see chapter 7.4 Loading a lighting project,
page 28.
4. Read the desired lighting mode, see chapter 7.5 Reading and viewing
the lighting mode, page 28.
If the lighting project contains several lighting modes, proceed as
follows:
1. Clear the lighting mode list. Observe the instructions on
page 29.
2. Read the desired lighting mode, see chapter 7.5 Reading and
viewing the lighting mode, page 28.
5. Click on in order to start the transfer.
If the transfer is successful, an acoustic signal will be emitted by
the controller and you will receive a confirmation message.
6. Close the message with [OK].
7. Disconnect the controller from your computer.
8. Connect the controller to the light and power supply unit (⌦B).
9. The controller now controls your EHEIM powerLED+ light in the desired
lighting mode.
31