Tripp-Lite NGI-U05 Manual Del Propietário página 10

Wiring Requirements
To insert power wire and connect the 9~48VDC at a maximum
of 0.5A DC power to the power terminal block, follow these
steps:
• Use a flat-head screwdriver to loosen the wire-clamp screws.
• Insert the negative/positive DC wires into the ( - / + )
terminals, respectively.
• Tighten the wire-clamp screws to prevent the wires from
loosening.
ATTENTION: Use a power supply from 9~48VDC.
The device power shall be supplied by SELV
circuit.
NGI-U16 with 2-Pin Terminal Block
You can use "PWR" for power input. Top view of the Terminal
Block is shown in the figure below:
+
PWR
-
12~48VDC
Terminal Block
10