Publicidad
Idiomas disponibles
Idiomas disponibles
Press
off existing modes. Press
To turn on Automatic mode:
1. Press
to turn on the colour jumping effect.
2. Press
to turn off the colour jumping effect.
To turn on Sound mode:
1. Press
to turn on sound mode.
2. Press
to turn off sound-active mode.
To turn on Strobe mode:
1. Press
on the remote controller.
2. Press
or
to either increase or decrease the speed of the program.
3. Press
to turn off the strobe.
To turn on Speed mode:
1. Press
on the remote controller.
2. Press
or
to either increase or decrease the speed of the program.
To adjust sound sensitivity for in Sound-Active mode
1. Press
on the remote controller.
2. Press
or
to either increase or decrease sound sensitivity.
1. Press
to turn on colour pulse effect.
2. Press
to turn off colour pulse effect.
Fade mode will enable colour gradiënt.
1. Press
to turn on colour fading effect.
2. Press
or
to turn off colour fading effect.
Manual mode has two functions. To turn on manual mode:
1. Press
on the remote controller.
2. Press
,
,
,
,
or
Press 1 time for 20% brightness;
Press 2 times for 40% brightness;
Press 3 times for 60% brightness;
Press 4 times for 80% brightness;
Press 5 times for 100% brightness.
1. Press
button again.
2. Press
,
,
,
,
or
3. Press
or
to either increase or decrease the brightness of each colour.
1. Press digit
to
to select preset colour mode.
2. Press
to turn off the preset colour.
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery contacts prevents the
battery from being discharged during storage. Prior to the first operation remove the foil from the battery support on the rear side of the
remote control. Otherwise operation of the remote control is not possible.
If the range of the remote control decreases, replace the battery. For this purpose, on the rear side of the remote
control press the small bar with the groove to the right (1) and at the same time remove the battery support (2). For
operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.
return the last modes.
(red, green, blue, white, amber or ultraviolet) to choose your colour.
(red, green, blue, white, amber or ultraviolet) to choose your colour.
Publicidad
