Uline SANITAIRE H-3480 Manual De Instrucciones página 2

Improper connection of an equipment-grounding
conductor can result in risk of electric shock. Check with
a qualified electrician or service person if you are in
doubt as to whether the outlet is properly grounded. Do
not modify the plug provided with the appliance. If it
will not fit the outlet, have a proper outlet installed by a
qualified technician.
This appliance is for use on a nominal 120 volt circuit
and has a grounding plug that looks like the plug
illustrated in Figure A. A temporary adapter which looks
like the adapter illustrated in Figure B may be used to
connect this plug to a two-pole receptacle, as shown,
if a properly grounded outlet is not available. The
temporary adapter should be used only until a properly
ASSEMBLY PACKET
(included with Owner's Guide)
Contains: two 2-part bolts, two screws, lower cord hook
and dual-zipper connector.
ASSEMBLY PACKET
Figure 1
B
PAGE 2 OF 22
Zipper
Connector
A
Lower Bag
Flange
DANGER
grounded outlet, Figure A, can be installed by a
qualified electrician. The green colored rigid ear, lug, or
the like extending from the adapter must be connected
to a permanent ground such as a properly grounded
outlet box cover. Whenever the adapter is used, it must
be held in place by a metal screw.
A
ASSEMBLY
CAUTION! Assemble vacuum FULLY before using.
1. Slide upper and lower handles together so holes are
aligned. (See Figure 1) Insert 2-part bolt in center
hole of handle. Tighten.
2. Hold assembled handle so handle curves away
from vacuum. Place lower handle into handle
socket at rear of vacuum. Align holes, insert 2-part
bolt and tighten using screwdriver.
3. Secure lower cord retainer into grooves at bottom of
handle. (See Figure 1A)
NOTE: Lower cord retainer should be aligned
with upper cord retainer so cord can be
wrapped for storage.
4. Plug extension cord into
pigtail. (See Figure 2)
Pull cord to tighten. Leave
enough slack so cord is
not strained when handle
is lowered. Wrap cord
around both cord retainers
and fasten plug to prevent
unwinding. For quick cord
removal, twist top hook downward.
5. Hold bag with zipper facing away from handle.
Align holes in lower bag flange with base of vacuum
and secure with two screws. (See Figure 1B) Loop
bag spring onto bag support hook on upper handle.
6. Insert one clip of the dual-zipper connector through
the eyelet of the zipper. Insert the second clip on the
connector to the remaining zipper eyelet. This will form
a looped zipper connector that allows both zippers to
be operated at the same time. (See Figure 1)
CAUTION! Do not use dual-zipper connector to lift
vacuum.
B
Figure 2
Extension
Cord
Pigtail
0917 IH-3480