Uline SANITAIRE H-3480 Manual De Instrucciones página 4

3. Place new dust bag collar on tabs of dirt tube
interface and rotate up until dirt tube tabs engage
holes in dust bag collar. (See Figure 8)
Figure 8
4. Tuck bottom of dust bag into lower portion of outer bag.
(See Figure 9)
Figure 9
5. Replace red bag cap and pull up on dual-zipper
connector.
REPLACING WORN BELTS
CAUTION! To prevent burns, avoid touching belt
pulley when servicing drive belt.
NOTE: Vacuum will not run at full suction if belt is
stretched or broken.
1. Turn vacuum upside down and turn power on. If brush is
not spinning, replace belt. See step 3 below.
2. If brush is spinning, gently place the bottom of your
shoe against brush roller. If brush roller stops, replace
the belt. See step 3 below.
3. To replace belt, release cam locks and remove bottom
metal plate. (See Figure 10)
PAGE 4 OF 22
MAINTENANCE CONTINUED
4. Pull up on belt and rotate off motor pulley. Lift out
5. Place new belt around brush roll. Insert rubber end
6. Stretch belt around the motor pulley. To do this, align
Figure 10
Cam
Locks
7.
Bottom
Metal
8. Spin brush. Brush should not rub against bottom
Plate
brush roll and remove worn belt. (See Figure 11)
Motor
Pulley
Belt
Groove
Brush
Roll
caps onto brush roll with arrows down. Align end caps
with slots in cleaner base and push brush roll into
base. (See Figure 12)
belt with belt guide and pull belt over motor pulley.
(See Figure 13)
NOTE: The belt is installed correctly if the lower
side of the belt runs parallel to the plastic belt
guide but is not touching it.
Figure 13
Belt Groove
Replace bottom metal plate and secure with cam
locks. Bottom metal plate will cover belt completely.
metal plate.
Figure 11
Belt
Guide
Belt
Figure 12
Side View
Motor
Pulley
Belt
Belt Guide
0917 IH-3480