C-LITE C-VT-A-LVT4 LED Serie Instrucciones De Instalación

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS
C-VT-A-LVT4 LED Series
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
should always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1.
DANGER- Risk of shock- Disconnect power before
installation.
DANGER – Risque de choc – Couper l'alimentation
avant l'installation.
2.
This luminaire must be installed in accordance with the
NEC or your local electrical code. If you are not familiar
with these codes and requirements, consult a qualified
electrician.
Ce produit doit être installé conformément à NEC ou
votre code électrique local. Si vous n'êtes pas familier
avec ces codes et ces exigences, veuillez contacter un
électricien qualifié.
3.
Suitable for wet locations.
Convient aux emplacements mouilles.
4.
Suitable for operation in ambient not exceeding 40°C.
Peut etre utilise a une temperature ambiante n'excedant
pas 40°C.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
DIRECT MOUNT INSTALLATION
1.
Locate and drill holes for the (2) mounting brackets. Use the
brackets as a template for hole locations. Spacing between
brackets is 33" (83.82 cm). Required hole size for provided
expansion anchors is 15/64" (6mm). Attach brackets to mounting
surface using provided hardware. See Figure 1.
2.
Attach the fixture housing to the mounting brackets by snapping
the housing into place. See Figure 2.
3.
Release the (10) lens retention clips to open fixture housing. See
Figure 3.
4.
Select desired wattage and CCT using the switches on the driver.
See Figure 4.
5.
Reposition lens assembly on fixture housing and close the (10)
lens retention clips to secure the lens in place. Make sure all
retention clips are properly engaged and no wires or cables have
been pinched to ensure proper lens retention and sealing. See
Figure 5 on back page.
6.
Route the fixture cord to a power feed location.
7.
Wire the cord leads to the supply leads as indicated in Electrical
Connections section. Make sure a wet location rated canopy and
cord grip is used.
http://lighting.cree.com/warranty
Document:
LPN00865X0001A0_A
Created By:
TMT
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
|
866.924.3645
Date:
11-01-2021

Publicidad

Tabla de contenido
loading

Resumen de contenidos para C-LITE C-VT-A-LVT4 LED Serie

  • Página 1 Document: Date: LPN00865X0001A0_A 11-01-2021 INSTALLATION INSTRUCTIONS Created By: C-VT-A-LVT4 LED Series FIGURE 1 CAUTIONS IMPORTANT SAFEGUARDS When using electrical equipment, basic safety precautions should always be followed including the following: READ AND FOLLOW ALL SAFETY FIGURE 2 INSTRUCTIONS DANGER- Risk of shock- Disconnect power before installation.
  • Página 2: Fcc Notice

    Document: Date: LPN00865X0001A0_A 11-01-2021 INSTALLATION INSTRUCTIONS Created By: C-VT-A-LVT4 LED Series FCC NOTICE FIGURE 5 CAUTION: Changes or modifications not expressly approved could void your authority to use this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
  • Página 3 Documento: Fecha: LPN00865X0001A0_A 01-11-2021 INSTRUCCIONES DE INSTALACIÓN Creado por: Serie C-VT-A-LVT4 LED FIGURA 1 PRECAUCIONES MEDIDAS DE SEGURIDAD IMPORTANTES Al usar equipos eléctricos, siempre se deben seguir medidas de seguridad básicas, incluidas las siguientes: LEA Y SIGA TODAS LAS FIGURA 2 INSTRUCCIONES DE SEGURIDAD PELIGRO: Riesgo de descarga eléctrica.
  • Página 4: Conexiones Eléctricas

    Documento: Fecha: LPN00865X0001A0_A 01-11-2021 INSTRUCCIONES DE INSTALACIÓN Creado por: Serie C-VT-A-LVT4 LED AVISO DE LA FCC FIGURA 5 PRECAUCIÓN: Los cambios o las modificaciones no aprobados expresamente podrían anular su autoridad para usar este equipo. Este dispositivo cumple con la Sección 15 de las normas de la FCC. El funcionamiento está...
  • Página 5: Mesures De Sécurité Importantes

    Document : Date : LPN00865X0001A0_A 01-11-2021 INSTRUCTIONS D’INSTALLATION Créé par : Série C-VT-A-LVT4 LED FIGURE 1 MISES EN GARDE MESURES DE SÉCURITÉ IMPORTANTES Lors de toute utilisation d’appareils électriques, les consignes de sécurité de base doivent toujours être respectées, dont les suivantes : LISEZ ET SUIVEZ TOUTES LES FIGURE 2 CONSIGNES DE SÉCURITÉ...
  • Página 6: Raccordements Électriques

    Document : Date : LPN00865X0001A0_A 01-11-2021 INSTRUCTIONS D’INSTALLATION Créé par : Série C-VT-A-LVT4 LED AVIS DE LA FCC FIGURE 5 MISE EN GARDE : Toute modification ou tout changement non expressément approuvé pourrait annuler votre autorisation d’utiliser cet équipement. Cet appareil est conforme avec la Partie 15 des Règlements de la FCC. L’utilisation est soumise aux deux conditions suivantes : (1) Cet appareil ne peut pas causer d’interférences nuisibles, et (2) cet appareil doit accepter toute interférence reçue, y compris les interférences pouvant...

Tabla de contenido