Main Menu; Go To Preset Or Start Tour - Dedicated Micros Dennard 2040 Manual

4.2 Main Menu

When called, the Main Menu screen will display the following options, against a camera display
background, with a cursor at the left hand edge:
Go to Preset
Start Tour
Technician Menu
Supervisor Menu
Exit
Using the joystick, or direction arrow keys, move up or down the list to select the feature required
then press the appropriate key(s) to accept/select it. If 'Exit' is chosen the menu is cleared and no
other action is taken by the dome.

4.2.1 Go to Preset or Start Tour

These selections allow the operator to recall the full range of stored Preset positions and Tours,
even if the control panel has neither the numerical range nor general ability to do so.
Note that this screen only allows existing preset positions and tours to be accessed. To set
up new presets or tours, see section 4.3.1 or 4.3.2
The display will prompt for the required numerical entry with the following subsidiary menu:
Preset Number _ _ _ (or Tour Number)
0 1 2 3 4 5 6 7 8 9
Accept Entry
Clear Entry
Return
The cursor can be moved across the numerical line, using the joystick or control buttons, until the
desired number is reached. The characters will flash their position in turn and, as soon as one is
selected with the ACCEPT button(s), will be displayed in the _ _ _ part of the display.
Leading zeros need not be entered (eg 001 may be entered simply as '1') but the entry must be
within range, eg 001 - 250 for Presets and 001 - 100 for Tours (Dennard 2060) and 001 - 100 for
Presets and 001 - 50 for Tours (Dennard 2040). Entries outside the range will cause an 'Illegal
Entry' message to flash, and the entry must be cleared and re-entered.
When the digits have been selected, Accept Entry will invoke that choice and the screen will
automatically clear to the desired camera position.
Dennard 2040 / 2060 Menu System Manual
All manuals and user guides at all-guides.com
Page. 11