Astralpool SENEXT XP Serie Manual De Instalación Y Mantenimiento página 13

• Check that there are no leaks in the hydraulic circuit.
• Check that the motor is turning in the right direction (look at the fan located at the back of
the motor). (See FIGURE 5)
• Switch the pump on and from the strainer lid check that the pump is fully primed for a time
of no longer than 12 minutes.
5. MAINTENANCE
Depending on the level of water cleanliness, the following should be done every 100 operating hours:
- Clean the pre-filter basket regularly to avoid drops in pressure. To prevent the basket from
breaking, do not hit it during the cleaning process.
- Should the pump stop, check that the consumption in amperes of the motor that is running
is equal to or below that indicated on the manufacturer's rating plate. If this information is
not available, contact the nearest Technical Assistance Service.
- Empty the pump if it is to remain at a standstill for a certain length of time, especially in
cold countries where there is a risk of freezing.
- Remove the purge cap to empty the pump.
- Every time the pre-filter is opened, clean the seal and its housing of any impurities to en-
sure airtightness when the cap is closed (FIGURE 6).
- Pump components that, due to their normal use, suffer wear and/or tear must be regularly
replaced to ensure good pump performance. The following table lists the fungible and /
or consumable components of the pump and the period of time in which they must have
been replaced.
Installation and general maintenance manual
FIGURE 5
- POOL PUMPS
CORRECT
INCORRECT
13