Uline TORK H-5808 Manual página 2

2. Drill four holes using 1/4" drill bit and remove
template from wall. (See Figure 2)
Figure 2
3. Insert anchors and screws. (See Figure 3)
NOTE: Do not tighten screws completely until
step 7.
4. Open dispenser and remove cartridge by pressing
top tab area and pulling outward. (See Figures 4-5)
Figure 4
Top Tab
Figure 5
PAGE 2 OF 18
INSTALLATION CONTINUED
5. Hold dispenser up to wall and align holes over
6. Lower dispenser onto screws. (See Figure 7)
Figure 3
7. Tighten screws. (See Figure 8)
Cartridge
screws. (See Figure 6)
Figure 6
Figure 7
Figure 8
0522 IH-5808