Please take the time to carefully read through this owner's manual to ensure that you are familiar with all of the functions of your
MasterEx Ex-PMR 1000 and know how to use them. For you own safety and information please read through the information on the
following pages.
1 - Antenna
2 - Channel switch
This knob is turned to select channel storage spaces 1–S (channel S can be programmed as a search run function) For pre-set channels
and pilot tones, see table: "Default Values of Channels" under Item 8.4.4.
3 - LED display
The red LED display illuminates when transmitting. The green LED display illuminates when receiving. The red LED flashes when the
battery voltage is low.
4 - ON/OFF and volume control
Turn the knob clockwise to turn the device on. To turn the device off, turn it counter clockwise until a signal tone sounds. When the
radio unit is turned on, this knob is used to control the volume.
5 - Loudspeaker
6 - Microphone
/
7 - PTT (Push to Talk-)
PTT is pressed for transmitting and PTT is released for receiving.
8 - Monitor key
Press the MONI key to monitor activities on the current channel.
9 - Loudspeaker/microphone sockets
When these accessory sockets are not being used, cover them up with the protective cap.
10 - Belt clip / 11 - Ex-battery module / 12 - Battery locking mechanism
All 8 channels are very easy to switch
The MasterEx Ex-PMR 1000 can be operated on all 8 channels.
FM for crystal-clear connections
Transmission is in frequency modulation (FM), which ensures lifelike and low-disturbance playback, as with the UKW.
16 channel storage spaces
So you always have sufficient fixed alternatives for your radio partners.
CTCSS & DCS
With CTCSS/DCS, you can ignore unwanted calls from other parties on the same channel. When CTCSS/DCS is set, the user can only
receive the calls on the same channel with the same CTCSS/DCS.
Please observe: Although you can ignore unwanted calls with CTCSS/DCS, this does not mean that your conversations are private.
-20-
All manuals and user guides at all-guides.com
8. Functional description / operating information
8.1 Display and control elements, connections
8.2 Functions