Publicidad
M.-Nr. 05719362
PWM 909, PWM 511, PDR 510, PDR 910 only
A
Place the supplied mat on the machine lid and align it with the edges of the machine lid with W = 1 3/8" (35 mm) and
Z = 3 1/8" (80 mm); see Fig. 1.
PWM, PDR machines
A
Place the supplied mat on the machine lid and align it with the edges of the machine lid with W = 2 3/8" (60.5 mm)
and Z = 1 1/4" (31 mm); see 2.
A
Drill 4 holes with Ø 1/4" (6.5 mm).
Installing the payment device
A
Open the front panel of the payment device.
A
Line up the mat (1) over the pre-drilled holes; see Fig. 10.
A
Secure the payment device to the machine lid using the supplied fastening materials; see Fig. 10.
Connecting the payment device to an electrical supply
PWM, PDR generation
A
Connect the connection cable to the Connector Box.
All other machines
The hole for the cable guide is provided at different positions depending on the model.
A
Attach the strain relief to the cable.
A
Feed the cable into the machine through the opening provided.
A
Attach the cable with strain relief to the opening.
A
Connect the connection plug (4) to the 7-pin socket in the machine (5); see Fig. 10.
An adapter may be required for payment devices C 4065 and C 4070. See the supplied information sheet "Notes for
the electrical connection of payment devices" mat. no.:05688614.
A
If used, secure the adapter to the wiring harness with cable ties; see Fig 10.
A
For C 4065 and C 4070, disconnect the jumpers (6) on the plug (5) in the machine in accordance with the information
sheet; see Fig. 10.
A
For C 4060, disconnect the jumpers (6) on the plug (5) in the machine in accordance with the information sheet;
see Fig. 10.
en-US
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
31 von 63
20.01.2022
Publicidad
