Setup; Battery Installation; Battery Saver; Code Saver - Zenith ZB410B Manual Del Propietário

Setup

Battery Installation

1. On the back of the remote, push down on the tab and
lift the cover off.
2. Match the batteries to the + and - marks inside the
battery case, then insert 2 AAA Alkaline batteries.
3. Press the battery cover back into place.

Battery Saver

Your remote automatically turns off if the buttons are
depressed more than 30 seconds.

Code Saver

You will have up to 10 minutes to change the batteries
in your remote without losing codes you have
programmed. However, do not press any buttons until
batteries are installed in the remote. If buttons are
pressed without batteries in the remote, all codes will be
lost.

Direct Code Entry

NOTE: You can store any kind of code under any mode
(except TV). I.E. you can store a VCR code under the
CBL button, or a DVD code under the SAT button, etc.
However, you can only store TV codes under the TV
button.
1. Press and hold the SETUP button until the red
indicator stays on, then release the SETUP button.
2. Press and release the desired mode button (TV,
SAT, etc.). The red indicator blinks, then stays lit.
3. Enter the 4 digit code from the code tables (on
separate sheet). Note: after a valid code entry, the
red indicator turns off. For an invalid code, the red
indicator fl ashes.
4. With your device on, press CHANNEL UP. If
the device responds, no further programming is
required. Note: If some buttons do not operate your
equipment, try one of the other codes for your brand.
6
All manuals and user guides at all-guides.com
Setup, cont.
Write your codes down here for easy reference later.
Type Type stored
TV
DVD/VCR
SAT
CBL

Code Search

If your product does not respond after you have tried all
the codes for your brand, or if your brand is not listed,
try searching for your code by following these steps.
1. Manually turn on the device (TV, SAT, etc.) to be
controlled.
2. Press and hold the SETUP button until the red
indicator stays on, then release the SETUP button.
3. Press and quickly release the desired mode button
(TV, SAT, etc.). The red indicator blinks off once.
4. Press the CHANNEL UP button repeatedly (up to
300 times) until the device to be controlled changes
channel. The red indicator blinks off with each
button press. If you accidentally overshoot the code
required, press the CHANNEL DOWN button
to backtrack through the library until the device
changes channel. Pressing CHANNEL UP changes
direction to forward again.
5. Press and release MUTE to install the code.
Most users will store SAT codes under the SAT button,
Cable codes under CBL, etc. If (for example) you want
to store a VCR code under CBL, fi rst follow the proce-
dure for Direct Code Entry (previous page) and press
CBL in step 2 of Direct Code Entry, then enter ANY
VCR code in step 3 of Direct Code Entry. Then fol-
low the steps above for Code Search (or Brand Search,
below). Note: If the device does not have a CHANNEL
UP button, use PLAY (VCR only) or POWER instead.
Code Search starts from the currently stored 4 digit
number under that mode.
Code
7