Brand Search; Code Identifi Cation Feature - Zenith ZB410B Manual Del Propietário

Setup, cont.
Code Search by Brand
Lets you search for a code for a specifi c Brand within
the Code Library for a particular manufacturer.
1. Turn on the device (TV, SAT, etc.) to be controlled.
2. Press and hold the SETUP button until the red indi-
cator remains on, then release SETUP button.
3. Press and quickly release the desired mode button
(TV, SAT, etc.). The red indicator blinks off once.
4. Press and release the numeric button (0-9)
corresponding to desired Manufacturer (see table
below). The red indicator blinks off once. Note,
pressing "0" performs a full library search same as
normal Code Search Method on previous page.
5. Press the CHANNEL UP button repeatedly until
the device to be controlled changes channel. The red
indicator blinks off with each button press. If you
accidentally overshoot the code required, press the
CHANNEL DOWN button to backtrack through the
library until the device changes channel. Pressing
CHANNEL UP changes direction to forward again.
6. Press and release MUTE to install the code.
Brand Search Method entry is now complete.
Note: When all codes under a Brand have been searched
the red indicator fl ashes rapidly for 3 seconds.
1 RCA, GE, SA
2 Zenith
3 Philips, Magnavox
4 Sony, Panasonic, Toshiba, Sharp, Pioneer
5 LG, Samsung, Hitachi, JVC, Sanyo
6 Echostar, Sylvania, Dish, Emerson, Fisher,
Hughes
0 All brands
8
All manuals and user guides at all-guides.com
Setup, cont.
Code Identifi cation Feature
The Code Identifi cation Feature allows you to identify
the 4 digit library code stored under your device key.
For example, if you want to fi nd out what 4 digit code
is stored under your TV device key, follow the six steps
below:
1. Press and hold the SETUP button until the red
indicator stays on. Release the SETUP button.
2. Press and release the desired mode button (TV,
SAT, etc.). The red indicator blinks, then stays lit.
3. Press and release the SETUP button. The red
indicator blinks off.
4. To fi nd the fi rst digit for the code stored under the
mode key pressed in step 2, press each numeric key
from 0-9 in turn. When the red indicator blinks off
the number you pressed is the fi rst digit for the code
you are searching for.
5. To fi nd the second digit, repeat step 4, this time
when the red indicator blinks off this is the second
digit.
6. Repeat step 4 to fi nd the third and fourth digits.
9