Firstech, LLC. FTI-FDK1 Instalación Y Configuración página 4

INSTALL GUIDE
Page 12 of 13
MODULE PROGRAMMING PROCEDURE - WITH TWO OEM KEYS
NOTE
I To complete this procedure,
both OEM keys are required.
II Keep both OEM remotes
at least 10 feet away from
the vehicule.
Use both valet keys for the
module programming procedure.
1
2
ON
3
4
5
OFF
6
ON
!
If the LED begins to fl ash RED, verify the RX and TX
connections between the module and the vehicle.
7
8
OFF
WWW.IDATALINK.COM
Patent No. US 8,856,780 CA 2759622
COM-BLADE-AL(DL)-FM2-EN
OR
Insert key 1 into ignition.
Turn key 1 to ON position.
If LED turns solid BLUE,
proceed with step 18.
If LED turns solid RED, proceed
proceed with step 4.
Wait, LED will fl ash BLUE.
(This may take up to 10
seconds.)
Turn key 1 to OFF position.
Turn key 1 to ON position.
If LED turns solid BLUE for 2
seconds, proceed with step 18.
If LED turns solid RED, proceed
with step 8 within 5 seconds,
after LED turns OFF.
Turn key 1 to OFF position.
FORD/LINCOLN/MAZDA/MERCURY
9
10
11
ON
12
13
OFF
14
15
16
10 AMPS
IGNITION
!
If the LED begins to fl ash RED, you are using a cloned
key or used the same key twice.
17
18
DOORLOCK INTERFACE
20190812
Doc. No.: ##65139##
Remove key 1.
Insert key 2 into ignition.
Turn key 2 to ON position.
Wait, LED will turn solid RED
then will turn OFF.
Turn key 2 to OFF position.
Remove key 2.
Press and release programming
button.
Remote start vehicle.
OR
Jump the igntion to 12volts.
Wait, LED will turn solid RED
then will turn solid BLUE.
Module Programming
Procedure completed.
Automotive Data Solutions Inc. © 2020