Anker PowerConf S500 Manual Del Usuario página 5

Option B: Connect to PC (USB-C Cable)
Connect PowerConf S500 to a PC using the provided USB-C cable. It will be ready to
use when it's powered on.
Option C: Connect to Smartphone or Tablet (Bluetooth)
1. When powered on, PowerConf S500 will automatically enter Bluetooth pairing
mode. Alternatively, press the Bluetooth button to enter Bluetooth pairing mode.
2. Select "Anker PowerConf S500" on your smartphone's Bluetooth list to connect.
Press
Flashing blue
Steady blue
• Each time you power on PowerConf S500, it will automatically connect with the
last successfully connected device if available. If not, press the Bluetooth button
to enter Bluetooth pairing mode.
• This speakerphone can pair up with two mobile devices via Bluetooth at a time.
To pair with another Bluetooth device, press the Bluetooth button to re-enter
Bluetooth pairing mode.
• When the speakerphone is connected to two devices via USB and Bluetooth at
the same time, press and hold the play button for two seconds to switch between
Bluetooth and USB modes.
• To disconnect the Bluetooth from one device, press the Bluetooth button again
on the device that's currently active.
• If connection via the Bluetooth dongle fails, plug it into a USB port on your PC
and then press the PC mute button four times. The light on the dongle will flash
quickly. This indicates that the dongle has been reset with all pairing history
cleared. The dongle will then connect with the speakerphone automatically.
03 EN
Pairing Connected
x1
Enter Bluetooth pairing mode
Pairing
Connected
Anker PowerConf
S500