Backlight - auna iTuner CD Manual De Instrucciones

EN
58
Software update and then press the SELECT button to confirm.
2. Press the
and then press the SELECT button to confirm.
Before downloading software, ensure that the radio is plugged into a
stable mains power connection. Interrupting the mains supply during
software download can lead to functional disturbances and/or damage
to the unit!
Setup wizard
The setup wizard is available in the system settings section; you can run
through this to configure settings for date/time and network. Once this has
finished, your radio is ready to use.
Info
1. During System settings mode, press the
Info and then press the SELECT button to confirm.
2. The software version, Radio ID and Friendly Name will show on the
display.
Privacy policy
1. To see the Privacy policy page, press MENU to go to System settings -
Privacy policy.
2. After Factory reset, you need to accept the Privacy policy again.

Backlight

1. During System settings mode, press the
Backlight and then press the SELECT button to confirm.
2. For the other settings under Backlight, press the
to select the following options and then press the SELECT button to
confirm.
Operation Mode
Standby Mode
Alternatively, press DIMMER button on remote control repeatedly can
adjust the Backlight level under ON mode and Standby mode.
If Timeout set Off, the display brightness at standby will keep as operation
mode not able to adjust by DIMMER button on remote control.
buttons to select Auto-check setting or Check now,
High / Medium/ Low
Timeout Off/ 10 sec / 30 sec / 60 sec
Standby Level High/Medium/Low/Off
buttons to select
buttons to select
buttons