INSTRUCTIONS FOR USE
Before use:
Make sure that the packaging from the filter has been removed (following the steps for installing filter).
FILTER INSTALLATION
Ensure the appliance is unplugged before removing or installing the filter.
When the power indicator keeps flashing in red, the filter should be replaced.
Please wipe the dust on the filter regularly, do not wash or use it repeatedly.
Please use the filter specially designed for this product.
Steps for installing filter (fig.1)
Unplug the power socket of the machine before replacing or installing the filter.
1. Invert the machine and rotate the base along the direction marked "Open".
2. Take out the filter from the appliance.
3. Remove the packaging filter into the item.
4. Then install the filter into the machine.
5. Then install the base, rotate and tighten the base along the direction marked "Close".
Note: Please press the power button for 7 s to reset after installing a new filter, and the anion indicator
light will stop flashing.
USE
When connect the appliance to the mains, the buzzer will ring for 1 second.
Button operation:
Power button (a)
Touch the power button to turn on the machine, the buzzer will ring for one time, blue light and the AUTO
grade of wind speed indicator lights on
Touch the button again, the button again, the buzzer will ring for one time and the machine will turn o
with all the lights o (beside the WIFI light).
Note: The machine will record the working modes when turns o without unplugging the power socket.
(beside the WIFI light).
Timer button (b)
In the condition of working, press the timer/WIFI button to set timer among the circulation of 2h, 4h and
8h timer with buzzer rings, and the corresponding indicator will be on.
Press again, the timer indicator turns o and the machine will work continuously without timer.
In the status of timing, the machine begins of count down. When the time is up, the fan will stop working
and all the lighting will be o .
Wind Speed button (c)
17