Lionelo Sander Manual De Usuario página 14

positioned in the ready safety seat. Fasten 5-point safety belts. Press belt adjustment
button (in front the safety seat) with one hand, use another hand to pull adjustment strap to
tighten arm belts. Make sure the belt pads remain on the child's arms. You can disassemble
the belts if your child weighs more than 15 kg or its height exceeds 1 meter (fig. 17).
Installation for Group 0+ (0-13kg) with ISOFIX
Position the backrest at maximum tilting (4-th position of adjustment). In this
position the backrest must be titled as much as possible. The safety seat must be
in a rear-facing position. To do so, slide ISOFIX guides to the front of the safety
seat (see instructions above, fig. 18). Mount the safety seat in accordance with
ISOFIX assembly instructions described above. Mount TOP TETHER upper strap
as instructed above. Press a red button on the clamp of 5-point safety belts to
unlock belts. Spread safety belts of the safety seat to sides, next place your child
properly. Combine two metal clamps. Insert two parts of the metal clamp in the
handle. If you can hear a click, the belt is locked. Make sure the belt has been
locked properly. Push belt adjustment to tighten harness of the safety belts. If
belts fit a child tight, the protection is fully guaranteed (fig. 18).
See fig. 19-The position of the safety
Installation for Group 0+ (0-13kg) with safety belts
Grip the red lever at the front of the child car seat and pull the seat into
its fully reclined position (fig. 20.1). The seat must be fully reclined when
facing rearwards. Plaing the child car seat on passenger seat. Placethe child
car seat on a passenger seat facing rearward (fig. 20.2). Routing diagonal
and lap belts correctly. Put the lap belt under innercushion (fig. 20.3).
In the meanwhile, bring the diagonal belt through the belt guide round the back
of the seat (fig. 20.4). Tightening the child car seat. Check and make sure there
is no twist of the belt. Insert the metal tongue of caberbelt into the carseat
buckle until you hear a clear "click" (fig. 20.5). Tighten the seatbelt by pulling in
the direction of the seatbelt reel (fig. 20.6). Pull the lap and diagonal seat belt
tightly and attach the belt lock to the diagonal section of the seatbelt. Ensure it's
attached as close as possible to the seatbelt buckle without touching it (fig. 20.7).
Installation for Group I (9-18kg) with ISOFIX
The safety seat must be in forward-facing position.
EN ‑ 14 ‑