Specifi Ca Ons; Charging The Ba Ery - Gallagher TW-3 Guia De Inicio Rapido

SPECIFICATIONS
Opera ng Temperature
Environmental Protec on Ra ng
Input Voltage
Es mated ba ery run me
CHARGING THE BATTERY
To ensure op mum performance of the TW- , the internal ba ery may need to be
charged for up to 16 hours before fi rst me use.
Important: If the TW- is to be stored for an extended period, this should be
in a cool dry place. For op mum ba ery life, store the TW-3 at 50% capacity.
Always charge the ba ery indoors.
1. Connect the power adapter at the base of the unit and plug the TW- into a
power outlet and switch ON. The charging icon will display on the screen.
Warning: The power adaptor is intended for indoor use only. Do not expose to
rain or dampness.
2. When the charge shows 100% the TW- is ready to use with or without the
power adapter.
Note:
• When the TW- is in use, the ba ery icon
will display and show remaining charge.
• When using the scale and the charge level falls below
10% the ba ery icon will fl ash with a red outline. You will have about 30
minutes to complete the weighing session before the TW- must be charged.
• When the charge level becomes cri cal the unit will shut down.
• To check remaining run me at current se ngs, from the Home screen, go to
Se ngs
• The ba ery error icon will display if the ba ery is too hot (above +45
or too cold (below 0
but will not charge properly un l at room temperature.
2
Gallagher TW- Weigh Scale Quick Start Guide
> About > Ba ery
o C). The Scale will keep opera ng while plugged in
-20 o to 50 o C
o o
-5 to 120 F
IP67
12 V DC
16 hours at 60% brightness
12 hours at 100% brightness
.
o C)