Smeg CB2485U Manual De Instrucciones página 11

Fig. 5 - Aligning the panel door
Close the door and check the alignment with the other unit
door (if applicable) or adjacent cabinets. Adjust the cabinet
door by screwing or unscrewing the adjustment/angle
alignment bolts for vertical adjustment and by the help of
the slots on the fixing bracket for other directions. Lock the
screws into place as shown in Fig. 5.
Fitting the cabinet door bottom brackets
With the appliance door open, locate the metal door lower f
fixing brackets and screw the bracket to the cabinet door.
You may need to remove and re-fit these brackets
depending upon the cabinet door style used.
Fitting the decorative cover
Re-fit the decorative cover, that you removed in the first
step, on to the cabinet door upper bracket.
Check that the whole door assembly operates smoothly and
that the door seals are still creating a good seal.
Tip: If you hear wood touch wood when a door closes, it's
possible the door panel is contacting the cabinet gable and
potentially preventing a tight gasket seal. Adjust the panel
further away from the appliance door to ensure a small
gap between the cabinet panel and the gable.
Ensuring the door seals correctly:
It is normal for the seal to be compressed after the door has been reversed.
With the door closed, use a hair dryer to expand the seal and fill the gap between the door and
the body of the appliance.
Take care not to use the hair dryer too close to the appliance, which could damage the seal.
A distance of approximately 10 cm / 4 inches should be adequate.
When completed, allow the seal and door to cool before touching them.
Once done, the seal will remain in position.
INSTALLATION INSTRUCTION
Fig 5
10