Controls - Smeg CB2485U Manual De Instrucciones

1. At first use, or after a power failure, the appliance always works at: 5℃ (41 ℉ ) for refrigerator, 0℃
（32 ℉ ）for fresh zone and -18℃ (0 ℉ ) for freezer. If you want to adjust the temperature or
functions manually, press any button to activate the control panel.
2. Refrigerator temperature adjustment: press button D on left-hand part of control panel multiple
times to cycle through temperatures from 2℃ (36 ℉ ) to 8℃ (46 ℉ ).
3. Freezer temperature adjustment: press button E on right-hand part of control panel multiple times
to cycle through temperatures from -15℃ (5 ℉ ) to -25℃ (-13 ℉ ).
4. Fast-cooling function: press button B; button illuminates and fast cooling function is turned on,
fridge will work automatically at temperature setting of 2℃ (36 ℉ ). Mode expires
automatically after 24 hours operation and illumination of button ceases. Mode can be canceled
manually by pressing the button again.
5. Holiday function: press button C; button illuminates, holiday function is turned on and whole
appliance will work automatically at settings: fridge at 17℃ (63 ℉ ) and freezer at -18℃ (0 ℉ ).
6. Smart function: press button F; button illuminates, fridge compartment operates at setting 5℃ (41
℉ ) and freezer compartment works at setting of -18℃ (0 ℉ ). The Fresh zone works at setting
of 0℃ (32 ℉ ).
7.Fast-freezing function: press button G; button illuminates and freezer will operate at temperature
setting -25℃ (-13 ℉ ). After 24 hours, fast freezing function quits automatically, or can be
ended manually at any time by pressing the button again.
8. Press button H for 3 seconds to switch off your appliance: the button lights up indicating unit is
powered but in a standby mode. Press the button H for 3 seconds to switch on your appliance.
9. Press the button A to temporarily turn on the display section corresponding to the fresh zone,
press the button A again to adjust the temperature. Temperature ranges of fresh zone from -3℃
(27 ℉ ) to 3℃ (37 ℉ ).
10. Fault display
This unit has a 'Fault display & alarm' function. If a fault is detected, there are alarms displayed on the
temperature display, the appliance still cools but professional service technician should be
called to check the appliance.
F1 – Sensor of fridge evaporator
F2 – Sensor of fresh zone
F3 – Sensor of fridge compartment
F4 – Sensor of freezer compartment
F5 – Sensor of defrosting
2E – Fault of fan/motor in freezer
EC – Communication fault between main panel and display panel.
PS: Main board is located in the compressor compartment

CONTROLS

17