PYD Electrobombas SUB Serie Manual De Instalación Y Mantenimiento página 14

OPERATING AND MAINTENANCE MANUAL
SUBMERSIBLE PUMP SUB SERIES
Other parts must not be disassembled. The functions of the motor and the pump can be
ENG
affected by an incorrect procedure or by tampering with internal parts.
7.3 Oil chamber
If the oil chamber needs to be inspected, follow these instructions:
CAUTION:
There may be slight pressure in the oil chamber. Care must be taken to avoid a sudden
spurt of oil. Wait until the oil chamber cover (34.03) has cooled down.
•
Before removing the mechanical seal (36.00), loosen the screws (70.18) and lift the cover (34.03),
applying force simultaneously at two opposite points on the flange of the cover, to release the
pressure in the oil chamber. Perform this operation while keeping the engine in the vertical up
position.
•
When refilling the chamber use only white oil suitable for food machinery and pharmaceutical use
(quantity = 35 g).
•
First fit the seal fixings (36.00) on the oil chamber cover (34.00) and then the oil chamber cover
(34.03) on the engine cover (70.00) with the O-ring (70.09).
8. TRANSPORT
The machines in question shall be supplied in suitable packaging to ensure proper protection during
all stages of transport. If, on receipt of the goods, the packaging is damaged, it is necessary to ensure
that the machine has not been damaged during transport and that it has not been tampered with.
In the event of damage to the equipment or if any part of the machine is found to be missing, the
transporter and the manufacturer must be notified immediately and the corresponding photographic
documentation must be provided. Materials used to protect the equipment during transport must be
disposed of using the disposal channels existing in the country of destination.
9. LIFTING AND DISPLACEMENT
For all lifting and moving operations, the operator must use the minimum personal protection devices
required for the operations to be carried out (safety footwear, gloves and protective helmet).
Machines with a weight of more than 25 kg must be moved using suitable handling systems with a
capacity greater than the weight of the machine to be handled (see the weight indicated on the pac-
kaging). If it is necessary to use belts for handling the machine, these must be in good condition and
www.proindecsa.com / proindecsa@proindecsa.com
14