Environmental Protection - BGS technic 8216 Instrucciones De Uso

SAFETY INFORMATIONS
•
Turn the engine only in the normal direction of rotation (clockwise unless otherwise specified)
•
Do not use locking tools for camshaft and crankshaft as a counter-holder, during loosening or
tightening screws on pulley, camshaft or crankshaft. This can damage tools and engine
components. Only use tools that are suitable for this purpose.

ENVIRONMENTAL PROTECTION

Recycle unwanted materials instead of disposing of them as waste. Packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with
the environment. Contact your local solid waste authority for recycling information. Dispose
of this product at the end of its working life environmentally.
USE
Use this tool to hold the Crankshaft Pulley Flange during
loosening the pulley flange centre bolt.
Note: Do not release the pulley flange centre bolt during the
camshaft and crankshaft timing tools are in place.
Always use the counterholder during loosen the centre bolt.
Use this tool to adjust the injector pump wheel.
Fine adjustment of the injection pump must be made with
special tools and by turning the injection pump.
The tool is used to adjust the camshafts.
Turn the camshaft until one side of the tool rests on the
sealing surface.
Measure the clearance between the tool and the sealing
surface with the feeler gauge on the opposite side.
Aligning the camshaft so that feeler gauge fits with half
clearance on both sides between ruler and sealing surface.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed