Battery Replacement; Cleaning And Maintenance - HOMCOM CALGARY 23G Manual De Montaje E Instrucciones

INSTRUCTIONS

BATTERY REPLACEMENT

The fire is supplied with an IR multifunction remote.
Before the remote will operate the plastic insulating sheet needs
to be removed.
Battery Requirements: CR2025
1. Locate and remove the battery bracket.
2. The battery has two sides, one with a button feature, and the other is flat.
3. Insert the battery with the button side down into the battery bracket, making sure the battery is
firmly seated.
Batteries should be removed if the product is to be left unused for a long period of time.
The batteries may contain hazardous substances that could endanger the environment and
human health.
This symbol appearing on the battery and/or packaging indicates that used batteries must not be
processed with municipal waste. Instead they should be brought to the appropriate collection
point for recycling.
By correctly disposing of used batteries, you prevent potential negative consequences for the
environment and human health. Recycling used materials also preserves our natural resources.
For more information about collecting and recycling used batteries, please contact your local
municipality, your waste disposal service or the store where you purchased this product.
SAFETY CUT-OUT SYSTEM
NOTE: The LED display panel will remain operational if the cut-out is activated, only the fan heater elements are prevented from
operating.
This product has one non-self-resetting overheat protection device (thermal cut-out) which will activate if the air inlets or outlets are
obstructed. For safety reasons the fire will NOT switch on again automatically, the following procedure must be carried out before the
fire can be operated.
NOTE: The visual effect will remain operational if the cutout is activated, only the fan heater is prevented from working.
Switch OFF the appliance at the wall socket or outlet. Leave the fire OFF for a period of no less than 10 minutes, ensuring all
obstructions are removed. Switch the appliance ON at the wall. Ensure the appliance is turned ON at the control switches. If the fire
fails to operate correctly, repeat the above procedure. If an attempt to switch on the appliance is made before the safety cutout has
reset, the appliance may cut out for a further period of time. If the sequence has been followed correctly and the appliance still fails to
function, check the fuse in the wall outlet. If this is not the cause, call an electrician or maintenance engineer.

CLEANING AND MAINTENANCE

ALWAYS DISCONNECT THE APPLIANCE FROM THE MAINS SUPPLY OUTLET
SOCKET BEFORE UNDERTAKING ANY CLEANING OR MAINTENANCE!
For general cleaning use a soft clean duster - never use harsh abrasive or cleaners. The glass viewing screen should be cleaned
carefully with a soft cloth.
If in doubt consult a qualified electrician.
Excluding fuses, use only genuine manufacturers spare parts available from your supplier.
Replacing the remote control battery:
When the battery becomes weak, the range of the remote control becomes shorter. Replace the battery with a new CR2025
lithium battery.
NOTE: Keep the lithium battery out of the reach of children.
UK-10