Section 1. Important Safety Instructions; Safety Instructions - Jandy TruDose Manual De Instalación Y Funcionamiento

Jandy TruDose Chemical Controller
® TM

Section 1. Important Safety Instructions

1.1

Safety Instructions

This device is for use with single-body swimming pool applications only. Not for use with dual-body pool and spa
applications, or stand-alone spas. All electrical work must be performed by a licensed electrician and conform to all
national, state, and local codes. When installing and using this electrical equipment, basic safety precautions should
always be followed, including the following:
SERIOUS BODILY INJURY OR DEATH CAN RESULT IF THIS EQUIPMENT IS NOT INSTALLED AND
OPERATED CORRECTLY.
INSTALLERS, POOL OPERATERS AND POOL OWNERS MUST READ ALL WARNINGS, CAUTIONS, AND
INSTRUCTIONS BEFORE USING THIS EQUIPMENT.
BEFORE USING YOUR POOL, SPA OR HOT TUB, CHECK THE pH AND SANITIZER LEVELS OF THE WATER.
RISK OF SUCTION ENTRAPMENT HAZARD, WHICH, IF NOT AVOIDED, CAN RESULT IN SERIOUS INJURY
OR DEATH. Do not block pump suction, as this can cause severe injury or death. Do not use this pump for
wading pools, shallow pools, or spas containing bottom drains, unless the pump is connected to at least two
(2) functioning suction outlets. Suction outlet (drain) assemblies and their covers must be certified to the latest
published edition of ANSI
Working with pool chemicals can be dangerous, always wear rubber gloves and eye protection. Always add acid
to water, do not add water to acid. Always work in a well-ventilated area. Splashing or spilling acid can cause
severe personal injury and/or property damage. Always follow all chemical manufacturer's warnings, cautions, and
handling instructions. When mixing, remember to always add acid to water.
DO NOT MIX SODIUM HYPOCHLORITE AND MURIATIC ACID.
When mixing acid and water, ALWAYS ADD ACID TO WATER. NEVER ADD WATER TO ACID. Read and follow
all the chemical manufacturer's instructions thoroughly.
To reduce the risk of injury, do not permit children to use this product.
Due to the potential risk of fire, electric shock, or injuries to persons, Jandy equipment must be installed in
accordance with the National Electrical Code
Canada, all local electrical and safety codes, and the Occupational Safety and Health Act (OSHA). Copies of the
NEC may be ordered from the National Fire Protection Association, 1 Batterymarch Park, Quincy, MA 02169, or
from your local government inspection agency.
Installation and operation of this equipment must be in accordance with Federal, State, and local building and
health codes.
DANGER – Risk of injury. a) Replace damaged cord immediately. b) Do not bury cord. c) Connect to a grounded,
grounding type receptacle only.
|
Installation & Operation Manual
READ AND FOLLOW ALL INSTRUCTIONS
/ASME A112.19.8, or its successor standard, ANSI/APSP-16.
® ®
(NEC
®
DANGER
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
), NFPA 70, or the Canadian Electrical Code (CEC) in
®
WARNING
Page 3
ENGLISH