Typical Installation - Jandy TruDose Manual De Instalación Y Funcionamiento

Page 8
ENGLISH

Typical Installation

NOTE: All chemical must be injected downstream
from the heater and flowcell.
GFCI-protected
Watertight Outdoor
Outlet
*See Note
Figure 1. Typical hydraulic installation of a TruDose Chemical Controller
1 Water sample to the Flow Cell
2 Water return from the Flow Cell
3
Acid introduction
Heater
Cell with
Flow/Temp/Salinity Sensor
Figure 2. Flow Cell Connection - Top View
pH 7.2-7.6
ORP 600-800 mV
Heater
1
3
Filter
Pool Return
Jandy TruDose Chemical Controller
® TM
*NOTE:
Mount power supply transformer 1ft (30 cm)
above ground surface.
pH
ORP
Flow Cell
Filter
Check Valve
PureLink
AquaPure®
Power Center
Control
Center
OR
TruDose Controller
Pump
2
Pool Intake
|
Installation & Operation Manual
Pump
From Pool
AquaPure Cell
Pool Return
TruClear XL
®
OR
Flow Cell
pH 7.2-7.6
ORP 600-800 mV