Greenlee Mobile Bending Table for 881 Hydraulic Bender Manual De Instrucciones página 10

5. Swing the forward tray up until it rests on the
carriage. (Fig. 2)
Figure 2
6. Assemble the bender forks and roller on the ground
before lifting onto the carriage. (See 881 Bender
Manual)
7. Slide the ram in between the connecting forks with
its scale facing the saddle/operator side of the cart
and secure with pins in the 2-1/2 in. conduit position
on the forks. (Fig. 3)
8. Fasten the 90° coupler to the ram coupling and
attach the hydraulic hose to the 90° coupler.
Scale
Figure 3
10
Pins
© 2021 Greenlee Tools, Inc.
9. Carefully swing the connecting forks and ram into
the vertical bending position and lock the forks in
place by revolving and pinning the carriage latches in
place. (Fig. 4)
Figure 4
10. Pin the yoke to the ram piston with the spring clip.
(Fig. 5)
Spring Clip
Figure 5
11. Place a 900 series hydraulic pump in the pump
basket so the front of the pump is facing away from
the pivot. Store the pendant in the holder on the
basket when not in use.
• The pump reservoir should be fastened to the
basket to ensure no movement during transport
through the underside of the basket. Different
pumps require different size screws and hole
patterns.
• 980: 1/4"-20 x ¾" L screws
• 940 and 960: 3/8"-16 screws
881MBTS
Carriage
Latches
52094216 REV 0