Bending Procedure - Greenlee Mobile Bending Table for 881 Hydraulic Bender Manual De Instrucciones

12. Attach the free end of the hose from the ram to
the pump coupler, make sure the coupler is fully
tightened to ensure proper ram function.
13. Load all accessories (Fig. 7 and 8).
Follow
Bars
Saddle
& Yoke
Pin
Figure 7
Shoes
Figure 8
52094216 REV 0
Shoe
Saddles
Ram
Positioner
© 2021 Greenlee Tools, Inc.

Bending Procedure

• Keep hands away from moving parts.
Fingers and limbs can be crushed.
• Use this equipment only in accordance with
these instructions, considering the working
conditions and the work to be performed. Use
of this table for operations different from those
intended could result in a hazardous situation.
• Do not stand in a direct line with the follow
bar while bending. The follow bar is under high
pressure during use and has potential to propel
forward rapidly.
Adjusting Ram Position
The ram positioner is used to adjust the position of the
ram within the connecting forks while in the vertical
position. (Fig.9)
1. To attach the ram positioner to the yoke, first rotate
the yoke 90° from normal bending position.
2. Pivot the ram positioner so the tabs are vertical to fit
between the connecting forks.
3. Rotate the rampositioner so the yoke connection
tabs are up.
4. Slide the ram positioner up and pin to the yoke.
Yoke
Connection
Tabs
Ram
Positioner
Tabs
881MBTS
Figure 9
11