Changing The Input Source; Setting The Date And Time; Setting The Date And Time Automatically; Setting The Date And Time Manually - essentiel b RRV-300DAB+ Instrucciones De Uso

Changing the input source

●
When your clock radio is in the audio mode, short press the
through the input sources and until the desired input source appears on the screen.
●
The available input sources are: DAB radio (default), FM radio, Bluetooth*, USB drive,
microSD card, and line in (auxiliary input).

Setting the date and time

Setting the date and time automatically

When your clock radio is switched on for the first time and your home area is already
covered by DAB+, the date and time are automatically set via the DAB/FM signal,
provided you receive a sufficiently strong signal. Consider extending the antenna fully.
The date and time are then synchronized during updates or automatic searches for DAB/
FM stations.

Setting the date and time manually

If the signal is not strong enough or you are not yet receiving DAB+, follow the steps
below to manually set the time and date.
Setting time
1. Put your clock radio into the clock mode if it is not in this mode.
2. Press the button to open the System menu.
button to open the first submenu, which is Time setup.
3. Press the
button to select the first menu item, which is Set clock.
4. Press the
5. Press the or
blinking. You can press and hold the
Press the button to save and continue.
6. Repeat Step 5 to set the minutes.
7. If the current time format is 12 hours, press the
PM. Press the
8. Press the button twice or wait about 10 seconds to exit the System menu.
Setting date
Follow almost the same steps for setting time.
●
In Step 4, press the
●
Perform Step 5 to set the day, month, and year one after another.
button repeatedly to set the hours when the hour digits are
or
button to save and return to the Time setup submenu.
button and then the
button to cycle
button to quickly change the value.
or button to select AM or
button to select Set date.
51
V.1.0