Uline H-801 Manual De Instrucciones página 2

4. Thread tape end through the bridge and pull out
over the brush. (See Figure 6)
Figure 6
SETTING FOR MULTIPLE TAPE ROLLS
1. Lift forward end of tape divider plate from slot and
the rear portion of the dispenser and place in the
desired slot that corresponds with the width of rolls of
tape. The combined widths are 2", 1/" and 1".
(See Figure 7)
Figure 7
• Keep tank 2/3 full for best moistening.
• Check water level periodically to ensure satisfactory
moistening of tape.
• Clean brush with soap and rinse once a week to
eliminate adhesive buildup.
PAGE 2 OF 6
INSTRUCTIONS CONTINUED
Tape Divider Plate
MAINTENANCE
1-800-295-5510
uline.com
OPERATION
1. Pull tape out in a slightly downward direction to
ensure thorough moistening. (See Figure 8)
Figure 8
2. When tape is at desired length, pull up against
blade to tear tape from roll.
• Remove cutting knife and bridge plate monthly for
cleaning.
• Periodically lubricate rolling bearing with a drop of
light oil to ensure efficient operation
0522 IH-801